2014-09-01; 08:48:25 EDT
Member Since
2014-05-06
Posts: 3821
My suggestion is a bit Draconian, Marc - but perhaps carefully targeted application of some epoxy would hold the nut while you tighten it (and forever thereafter). Alternately, you'd have to enlarge the hole sufficiently to get on it with a socket - but that I don't have any good ideas as to how to make that happen and keep the tiller's aesthetics intact, short of sanding the surface down to expose the nut, then re-finishing the area you just worked. Dennis McNeely Magic Moments Bobbing about and ready to go...See the original archive post