2014-09-01; 16:18:53 EDT
Member Since
2014-05-06
Posts: 3821
You may need to ignore everything I've written in this thread, Graham. It suddenly dawned on me that RC in your subject line refers to Rhodes Continental - which may differ significantly from the 'conventional' Rhodes 22 trailer I've been describing. In the interest of being complete (or completely useless), here's part 3 of my comments: See if you can add some additional supports to the bunks. One thought is to use pivoting scaffolding jacks, as shown at http://www.scaffoldexpress.com/Scaffolding-Screw-Jack-w-Swivel-Base-Plate-p/ psv-164.htm. Cut short sections of black iron pipe at an angle, so the pipe 'points' at the bunk when welded to the trailer frame rail (see the attached). Mount the jacks upside down, sticking the threaded end in the pipe and securing the pivoting base to the underside of the bunk; you'll probably need to cut the scaffolding jack down a bit. When you extend the jack, you'll be taking more of the weight of the boat on the bunk. Add one or two jacks to each bunk. Double nut each support jack if you want to count on its support while trailering. Also, you can wedge a piece of 2x vertically under the bow eye and secure it temporarily through the winter with a C clamp on the trailer frame to take some of the weight of the bow. Lastly, consider glassing in a temporary bulkhead (another piece of 2x) in the bow, between the forward bunk supports. You can cut it out when you add reinforcement to the interior at a later date. Taken together, the above is probably overkill, but you may find something worthwhile to prevent stress cracks, despite the fact I had the wrong trailer in mind :-/ Alternately, you may just decide to continue letting the keel bear the brunt of the boat's weight and be done with it. Dennis McNeely Magic Moments Not much sailing today, but got my jones fixed!! Support for trailer bunks.JPGSee the original archive post