2014-09-10; 15:04:15 EDT
Member Since
2014-05-06
Posts: 3821
Mike, Why indeed would I want to forgo sailing almost an entire season to take apart my boat? 1. Either the original factory laminate was not that solid. Stan mentioned that he farmed out some of the early hulls to Loftland, KS. 2. My boat was severely abused by previous owners. Water was allowed to stay in bilge, cabin and centerboard trunk for long periods of time (probably years!) I've added many additional layers of glass to small sections of the bow area and wanted to address the flexing of the mid to stern areas of my hull by either cutting holes into the cockpit floor and working sections of the hull that way or taking the two sections apart and just re glassing as much as I could. While this method seems the most efficient, there is a good chance the two sections will never fit properly again and that it wouldn't be possible to pull them apart without ripping the important shoe box flange. 3, I figured this was going to be my final attempt to restore the boat to a near pristine condition and was willing to take the chance since I had to remove the rub rail anyway. I will most likely just add some glass to the exterior hull around the bow and aft where the boat stands usually are placed. Somehow I was able to stop the annoying leak with my final layers of glass on the bow this spring and the boat sails great. I just wanted to know if anyone out there had done the most difficult part of the restoration process themselves. thanks for your response. Lou sv Miracles Mill Basin Bklyn -- View this message in context: http://rhodes-22.1065344.n5.nabble.com/hull-deck-joint-reseal-questions-tp45504p48567.html Sent from the Rhodes 22 mailing list archive at Nabble.com.See the original archive post