The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Rigging repair

2014-10-05; 22:33:22 EDT

Member Since

2014-05-06

Posts: 3821

Does your stay run through a bushing? If I remember correctly, a small
screw held the bushing in the tube at the top end. The stay had about 5" of
slack. Took top bushing out and pulled stay down through to the bottom. Had
to remove bottom bushing to release the stay through the spool at the
bottom. Mine is a simple spool that spins around the stay. Your furling
spool may  .  Be different. The heavy washer fits above the solid
sleeve/swage at the base of the stay.(see picture)...there was also a multi
hole extender connected to the top of the stay that has to be removed. Dont
forget to replace that.  Take before pictures...good luck
Chris
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting