The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Galley counter top question

2014-10-07; 16:34:54 EDT

Member Since

2014-05-06

Posts: 3821

One other thing, for the countertop I just used regular post-formed MDF
counter top that I got from the scrap bin for about $10 at a lumber store.
To make it fit I cut off the rounded front of the counter and attached a
piece of teak. A better way to make it would be to attach the teak edge to a
piece of MDF first and then glue down a piece of Formica or similar counter
material and then round over the top edge with a router. This approach
exposes the teak, covers the join between the teak trim and the edge and the
MDF so there is no visible crack. I did this with the bulkhead exposed edges
and it looks great.

Next time I will coat the edges and underside with epoxy. It held up fine
but the epoxy would no doubt be a reasonable enhancement. Installing the
bulkhead for the locker also provided an end wall to hang the countertop.
With the small sink I found that no other support/divider was necessary.
Also, for a cooler, I used a large plastic Coleman cooler (24x14x14) that
fit perfectly in front of the locker and under the companion way. I attached
strips of teak with hot glue to the top to protect the cooler from foot
traffic as it became a perfect step when entering the cabin. This gave me a
large cooler than what would fit under the counter, freed up a lot of space
under the counter and made a convenient step down into the cabin and cost
only the price of the cooler. I have attached a picture of the cooler. Much
to my surprise the teak steps have remained attached now for about 20 years.

Graham Stewart



2014-10-07 16.25.11.jpg
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting