The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



No questions. Just a photo of my 2014 Recycled 1998 Rhode...

2014-10-11; 13:37:42 EDT

Member Since

2014-05-06

Posts: 3821

You will have to drill a hole in the cap large enough for the shroud end to 
 fit through. I used rigging tape to hold the cap in place and also to 
cover the  rough edge. I have seen another installation where a second, larger 
piece of pvc  was put on the outside of the inner tube, but I think that is 
over kill and  looked bulky to me. I didn't notice any performance 
improvement over the single  tube.
 
Rummy
 
 
In a message dated 10/11/2014 8:48:41 A.M. Eastern Daylight Time,  
rhodes22-list at rhodes22.org writes:

I have a  couple short shroud protectors made from pvc pipe and I didn't put
any end  caps on them. I assume this holds them down in place? Looks like I
need to  try the longer ones. Thanks for the  photo.

Bob



--
View this message in context:  
http://rhodes-22.1065344.n5.nabble.com/Re-No-questions-Just-a-photo-of-my-2014-Recycled-1998-Rhode-tp48693p48697.html
Sent  from the Rhodes 22 mailing list archive at  Nabble.com.
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting