The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



My new toy.... Talk me into saving it

2014-10-30; 12:04:25 EDT

Member Since

2014-05-06

Posts: 3821

Hi Rummy:
If you would send me the specifications for the floor as well I would
appreciate that. My floor is completely removed and while I kept the old
pieces to aid in the reconstruction, those were not the original pieces and
having the plans would be very helpful. My email is gstewart8 at cogeco dot
ca.

You are also absolutely right about the keel worries. I should have
mentioned that as well especially given what I went through this year fixing
my keel. Also, it appears that Brad has some cement ballast on the inside of
the hull which I assume is what has been breaking up. My boat does not have
cement ballast inside the hull but instead a set of steel blocks.  It is
hard to imagine what would break up cement like that other than water
freezing and if that has been the case it might indicate other serious
problems. 

The problem is in determining what has occurred inside the keel itself.
First thing I would do is take the cap off and check the inside walls of the
centreboard housing. If they are pushed in from water entering the keel and
freezing I would agree with you that, considering all of the other problems
with the boat, it probably is beyond any reasonable prospect of repair.

If the housing does not show evidence of freezing damage it would not be so
difficult to remove the cement and replace it with other ballast. As I
discovered, getting inside the keel from inside the boat is just about
impossible for a mere mortal. You can drill holes into hollow spots from the
outside of the keel to see if any water runs out and to let it dry out so
long as the boat is protected from rain entering. Over the course of the
time it would take to repair the boat in a northern climate (years) the keel
should dry out. In my case I then filled all of the voids I could find with
polyester resin - for my keel that took 3 gallons! 

Brad mentions that all of the hardware feels loose and needs backing plates.
My suspicion is that the damage to the core is the problem in which case it
might be much more extensive than just the foredeck. Not a good sign.

Graham 


See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting