The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Deck core repair

2014-10-30; 14:17:46 EDT

Member Since

2014-05-06

Posts: 3821

In responding to Brad about how I repaired the core in my foredeck I might have left the impression that I thought that removing the deck entirely was the best option. In fact, I think it is an option that would only be best in specific circumstances. 

It occurs to me that there are four approaches - others might be able to add more:
They are, in order of my preference: 1, epoxy injection, 2, removal of the deck skin, 3, total removal of the deck, and 4, removal of the liner.

These are the circumstances under which I would consider using each of these alternatives:

1, Epoxy injection:
I think this would ONLY work where the core material is solid and completely dry. Injecting epoxy into punky wood is just a waste of time. What injection will do is address delamination and greatly increase the rigidity of the core. This is the fastest, cleanest and easiest alternative but needs to be done properly to avoid only pumping epoxy through the core to pool, uselessly, on the inside surface of the liner.

2, Remove the Deck skin: 
This would be done by using a tool like a rotozip to cut around the outside edge of the deck, lifting off the skin, replace the core material and then replace the skin. This would be my first choice if I thought that the core material was wet but the deck skin still had its shape. The big advantage is that the work is below you and you are working in a lighted, ventilated environment and in a comfortable position. Gravity is on your side. The disadvantage is that your deck will have cuts all around it that will need to be repaired. Because most of the cuts will go through the non-skid pattern you will probably need to do fairly extensive repairs depending on the outcome you are looking for.

3, Remove the deck entirely and rebuild in your shop: It is not hard to remove the deck but not so easy to reinstall it but this might be the best option if the deck is badly out of shape. You need to construct a frame that will hold the deck skin in its proper shape while to insert the new core material. It would be difficult, I expect, to rebuild the core and insure proper shape using any of the other methods.

4, Remove the inside liner: This could be done using a rotozip much as the outside skin could be removed. The   big advantage here is that the deck is not marked up. The disadvantage is that you will be doing the work overhead in a very cramped spot that is not easy to get in and out of. Because gravity is working against you. you will have to work out a system of braces to keep things up there while the epoxy cures and live with the prospect of wet epoxy dripping on your face. It is also dark and has poor ventilation. The prospect of working under those circumstances thoroughly discouraged me. The other problem is that the liner is very thin and it might not be possible to remove it without breaking it. (The deck skin is much thicker.) I think I would consider this approach only when the area to be repaired is very localized.


With the experience I now have, I would have been better to have used the injection method for the deck with the exception of the one wet area around the vent. The problem is that until you get in there it is very difficult to tell what you are dealing with so under those circumstances removing the top skin would probably have been necessary. I was able to determine that the side decks had solid core material. I was able to repair those decks in about a day's work while the foredeck took about a weak to repair and forever to reinstall.


Graham 

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting