Ps...that was Chris Greco.... Took about 5 hours, for me but saved me from having to pull the boat out of the water. The key is to replace them only one at a time and snug them up before proceeding to the next.
Chris Greco
Sent from my iPad
> On Nov 7, 2014, at 4:59 PM, The Rhodes 22 Email List <rhodes22-list at rhodes22.org> wrote:
>> Also,
> Once you get her on the hard, photo's of what you are currently working
> with would be very helpful. The main reason for not using a sealant are that
> future disassembly/assembly becomes nearly impossible since anything that
> can withstand being constantly wet and under pressure will not want to come
> apart easily.
>> Rummy
>>> In a message dated 11/7/2014 2:52:54 P.M. Eastern Standard Time,
>rhodes22-list at rhodes22.org writes:
>> After a successful mast raising and launch, I sailed my new to me
> Rhodes 22 for an hour or so. Tied up in my slip and went home to bed.
>> Next morning I found boat with water in the main cabin at bunk height.
>> A little bit of panic followed by a friend bringing a homestyle sump
> pump which quickly brought the water down to the top of the
> centerboard truck.
>> Obvious that several bolts near the front of the centerboard trunk
> were not very tight. Tightened them and greatly reduced leakage.
>> Called Stan and he confirmed washers were too small. Bought some one
> inch fender washers and replaced 10. Still have very slight leak near
> bolts even after replacing washers.
>> I can't get a hold of Stan today. Will someone please give me all the
> details on how to properly fasten the centerboard trunk flange.
>> Unfortunately my computer was on board down low and was ruined. This
> is handicapping me from researching
>> Gasket questions
>> It has a brand new rubber gasket.
>> I understand no sealant should be used, correct?
>> 1 inch fender washer under bolt head?
>> What is correct washer size for the nut on the underside? Should I use
> a lockwasher? Or should I get nylock nuts?
>> What is proper torque?
>> Finally, can someone explain what the three little bolts are which go
> through a rubber pad on the top of the centerboard trunk. What is the
> proper way for them to be installed?
>> Can you please respond directly to my email rather than waiting for
> the list to send a group of responses.
>>bridges.brooks at gmail.com> __________________________________________________
> To subscribe/unsubscribe go to
>http://www.rhodes22.org/mailman/listinfo/rhodes22-list>> For the list Charter and help with using the mailing list and archives go
> to http://www.rhodes22.org/list> __________________________________________________
>> __________________________________________________
> To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list>> For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list> __________________________________________________
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.