2014-12-10; 07:18:27 EST
Member Since
2014-05-06
Posts: 3821
Todd, I don't remember the length of the rivets, but they were much larger than anything I had previously used. I would guess they were at least in the one inch range. No additional washers were used and nobody inside. The pop rivet draws the two sections together. I didn't work in short sections. With the hull on the trailer I removed all old rivets and did the procedure. The rivets were aluminum. The size would be partially determined by the drill size you used to drill out the old rivets. I would recommend using a piece of wire with a hook on the end to find the depth of the hole. You would want at least another half inch on the inside for expansion. Unfortunately, I did this probably fifteen years ago and don't have any rivets in my junk drawer. I do remember wishing I had a pneumatic riveter. I was younger and stronger on those days. Rummy In a message dated 12/9/2014 9:05:02 A.M. Eastern Standard Time, rhodes22-list at rhodes22.org writes: Rummy, I have a few questions about your procedure... when you have time. Do you remember the grip length of the pop rivets? Were they aluminum, stainless steel, etc.? Did you use washers inside? If working in short sections, it's the hull rigid enough or do you need someone inside pushing against the hull lip as you draw the joint right with the rivets? Any additional info world be extremely helpful. Todd T. -- Sent from my Android phone with [1]mail.com Mail. Please excuse my brevity. The Rhodes 22 Email List <rhodes22-list at rhodes22.org> wrote: Chuy, I'm a little short on time, but I will try to detail the procedure the best I can. Remove the rubber insert from the rub rail. In most cases it has deteriorated enough that you will want to replace it with new. Having removed the insert you have found the pop rivets which you will have to drill out in order to remove them. Most of the rivet will fall into the interior of the boat and you will continue to find them for several years. After drilling all the rivets out you will clean the deck joint (area between the two surfaces) with something small enough to remove the hardened and worthless caulking. The cleaner the joint is, the better. I recommend and used on my boat a one part polyurethane sealant called NP1. It is manufactured by a company called Sonolastic and is primarily used in roofing applications so it has great adherence and weathering properties. It will stick to anything and can be easily found through Google. Now comes the really important part, filling the voids in the seam. Using a caulking gun, you will squeeze the trigger as you push the gun forward, driving the caulk into the seam. This is reverse as to how you normally apply caulk, but you want to fill all the voids. Once the seam has been sealed, replace the rivets which you have purchased from an industrial nuts and bolts supply house and attach the rub rail. Count the holes before going and add 10% just because. Do not try to find them at a hardware store, they don't have them. I used a hand operated pop rivet gun, but I would recommend purchasing a pneumatic or electric gun to save wear and tear on your hands and arms. Simply sealing the top and bottom edge of the rub rail doesn't do squat for stopping water infiltration and besides, it looks crappy. Good luck and if you have any further questions don't hesitate to ask. Rummy In a message dated 12/8/2014 12:52:48 P.M. Eastern Standard Time, rhodes22-list at rhodes22.org writes: Rummy, Searched list but did not find any material on your deck join repair. I would appreciate if you could repost. Chuy ---- The Rhodes 22 Email List <rhodes22-list at rhodes22.org> wrote:See the original archive post