The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Boat lift

2014-12-13; 15:34:28 EST

Member Since

2014-05-06

Posts: 3821

All I did was have some "extensions" fabricated out of steel that 
replaced the short ones that held the bunks to the lift designed for 
power boats.  The extensions were made to be long enough to allow the 
keel to clear the hoist frame, which as I recall was about 24" (but 
that's from memory -- you should measure!)  I would suggest you make 
them a little longer than needed, and put in some extra mounting holes 
to make them adjustable.  Mine have been in place for three summers 
(fresh water) and have worked fine.  The bunks flex to hold the boat 
just like the trailer does.  Nothing else supports the boat.

Bruce
s/v Tuxedo

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting