The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



deck mounted chain plates

2015-01-11; 15:12:44 EST

Member Since

2014-05-06

Posts: 3821

Hi Richard:
The upper shrouds go to chainplates that are bolted to the hull but the
lower shrouds, at least in the case of my 1979 model, go to chain plates
that attach to the cabin top. 

The chainplates, which look more like tangs to me (i.e., thinner), go
through the outer fibreglass skin and simply bend under the plywood core.
The end is held in place with a 1/2 inch screw. The screw merely holds the
chainplate in place and does not take any of the load. I have attached a
picture of one of my lower shroud chainplates after removal. I also attached
a picture of the cabin top after the chainplate was removed and the area
ground out prior to being filled. The third photo shows the cabin top after
the repair and with a base coat of paint. It is good enough job that I now
have no idea where the chainplates should be placed. I was very clever to
measure the exact locations of the upper chainplates before removing them. I
was not so clever, however, to put my notes where I can find them now. If
anyone with access to their boat at this time of year could give me the
precise measurements for the location of the upper chainplates, I would be
most grateful.

Given that my old chainplates did not fail in 35 years, that makes me think
that the lower shrouds don't carry a large load and I am convinced by
Dennis's logic that the fittings I have in mind are at least as strong, in
fact, are much stronger than the original. The metal is thicker on the
proposed chainplates, there are two pieces rather than one and they are
attached with two 1/4"diameter bolts. That has to be stronger than the
original bent tang. That was my thinking as well but I wanted to check it
out with those on the list who seem better qualified to make such
judgements. Mike's reference to articles that "allow me" to, in theory,
calculate the stress and loads is great but a tad over my head. I should
have known that if I asked for advice on this I would get more than I could
handle.

The problem with the old upper chain plates was that they flex with the
result that the fibreglass cracks around the hole where they come through
the cabin top. Water can get in easily and it seems impossible to
permanently seal the opening and having water get into the cabin top core
seemed lake a potentially serious problem to me. Also, it is not possible to
inspect or remove the chainplates without cutting into the head liner or
doing major damage to the cabin top - as my second photo demonstrates.

Stainless steel does rust in an oxygen free environment and , indeed, some
of mine showed rust where the bend is hidden in the cabin top. So, since I
am doing a major rebuild and would have to paint the deck anyway, it seemed
like the right time to change the chainplates. 


Graham 



Chainplate.JPG

Chainplates removed 2012.JPG

cabin top repaired and primed 2013.JPG
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting