The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Chain plates and loos gauge.

2015-01-12; 11:22:21 EST

Member Since

2014-05-06

Posts: 3821

Case in point: somebody mentioned the Loos settings recommending 
240lbs.  If you did that for the inner shrouds you'd have a total 960lbs 
of force on the cabin top.  Does not sound wise to me and probably cause 
some cabin top distortion.

Most of the load should be on the outer stays.  If you're seeing 
distortion of the cabin top under sail from the inner stays something is 
not right in your rigging.  There's too little tension on the outer 
stays and/or too much on the inner ones.

Remember we're talking about the inner stays here...  I remember reading 
quite a while back that their primary function was as backup to the 
outer stays, so you don't lose the whole rig if a main stay mails.  
Consequently they should probably not have much tension at all.  I 
couldn't put a number on it, but I'd say take the slack out and give the 
turnbuckle another turn or so and that's all.

--
Cheers!
John Lock
~~~~~~~~~~~~~~~~~~
s/v Pandion - '79 Rhodes 22
Lake Sinclair, GA
~~~~~~~~~~~~~~~~~~


See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting