The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



deck mounted chain plates

2015-01-12; 14:57:53 EST

Member Since

2014-05-06

Posts: 3821

Graham,

A drawing showing measurements for the aft lower tangs is attached. 

I used a carpenter's square to make the measurements. I butted the corner of
the square against the aft end of the tab and read the measurement at the
leading edge of the lower radius where the cabin top is raised about 1/2",
near the back of the pop-top. I then put the corner of the square against
the lower edge of the radius where the pop-top rim meets the cabin top and
measured radially out to the aft end of the tang, at its inside edge.

Hopefully you can make sense of the measurements. Let me know if you'd like
to have them referenced differently.

Dennis
Magic Moments
Leaving the imperial-metric conversions to the more able minded




Measurements - aft lowers.JPG
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting