The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Chain plates and loos gauge.

2015-01-12; 15:35:50 EST

Member Since

2014-05-06

Posts: 3821

The guilty party responds...

The total load on the cabin top *is* outrageous, John. If you believe Loos,
the forestay tension will be about 320 pounds when you've tightened the aft
stays to about 180 pounds, the shrouds should be tightened to about 240
pounds, and the lowers should be 240 pounds. You could make a case for
reducing tension on the lower stays, since the Rhodes has 4 lowers - versus
most other boats having just two. Even if you reduce tension in the lowers
though, you still a *lot* of compression in the mast. On top of that load,
the compression in the mast probably goes up when you've got the rail in the
water, as Graham noted. (I'm looking at you here, Rummy!!)

After you get done playing with the trig functions on a calculator, you'll
find the cabin top is supporting nearly 2,000 pounds. The bottom line is
that you'd shove the mast through the cabin top if it weren't for the
compression post under the mast, which carries the compressive load to the
keel.

FWIW, the function of the lower stays is to keep the mast "in column".
Translation: the mast can bow and break if there's too much compression or
lateral load. For example, if you take a yard stick and push straight down
on it, all will be well - until you get to 5 or 10 pounds of pressure. At
that point, the yardstick will bow and may break. If you had someone hold
the middle of the stick while you pushed (the job of the lower stays), the
yardstick could carry much higher loads.

We can kick this thing around till the cows come home, but if we'd like to
get to the bottom line, we need to get General Boats to weigh in. Stan??

Dennis
Magic Moments
Needing enlightment - the tension is killing me :)
 

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting