The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Centerboard cap

2015-01-14; 18:13:42 EST

Member Since

2014-05-06

Posts: 3821

GB no longer (I think) uses screws but through bolts with stainless bolts, washers, and nuts.  I can not remember size (1/4"?).  When I popped the cap to replace the line on my '86 I found the blocks to be bent up and the plasmic on one gone and replaced all with all stainless blocks. I replaced the screws with the recommended bolts.  As you are that far into it, I would take the cap off and inspect.  If all is well, chalk it off as a learning experience.

Bob in Florida "NoKaOi 3"

Sent from my iPad

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting