The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Soul of the sole

2015-01-15; 10:43:28 EST

Member Since

2014-05-06

Posts: 3821

3m 5200 It is what most manufacturers are using for hull to deck sealants.  It is true it is an adhesive. But, it is a waterproof strongly adherent, flexible one.  If removed you do have to grind it off with a power drill and wire brush.  It may also make the boat less desirable to recycle.
The 5200 adhesive and 4200 sealants are moisture cure polyurethanes.  Water causes it to cure and set up.  I do not believe Silicone is the treatment of choice, though it would work for a while.  It looses its adherence over time with the flexing of the hull and will wick moisture in by capillary action within a few years.  Silicone also shouldnt be used below the waterline ever! and someone used it to seal my through hull joints.  I have to take them out and seal them properly too.
Who out there has used silicone and what is your experience? Silicone is cheaper and great for house windows but i dont think it has a place on board a boat.  It isnt totally waterproof and breaks down very fast in a salty, warm environment. If you are bedding hardware you might want to remove in the future, perhaps 3M 4200 might be the way to go.
Lets ask Rummy!
Bob

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting