The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Soul of the sole

2015-01-15; 11:59:02 EST

Member Since

2014-05-06

Posts: 3821

Bob,
I've answered this question several times recently and my choice remains  
the same. I use a product called NP1. It is a single part polyurethane that 
is  extremely sticky, remains flexible and doesn't harden over it's expected 
life  expectancy of 15 years when exposed to direct sunlight and weather.
Silicon is not a good choice as it does not adhere to surfaces. It is  
designed to be used as a sealant,such as in installing gaskets which are under  
pressure. It could be argued that the deck joint functions like this, but in 
 reality it doesn't. 
 
Rummy
 
 
In a message dated 1/15/2015 10:43:45 A.M. Eastern Standard Time,  
rhodes22-list at rhodes22.org writes:

3m 5200  It is what most manufacturers are using for hull to deck sealants. 
 It is  true it is an adhesive. But, it is a waterproof strongly adherent, 
flexible  one.  If removed you do have to grind it off with a power drill 
and wire  brush.  It may also make the boat less desirable to recycle.
The 5200  adhesive and 4200 sealants are moisture cure polyurethanes.  
Water causes  it to cure and set up.  I do not believe Silicone is the treatment 
of  choice, though it would work for a while.  It looses its adherence over 
 time with the flexing of the hull and will wick moisture in by capillary  
action within a few years.  Silicone also shouldnt be used below the  
waterline ever! and someone used it to seal my through hull joints.  I  have to 
take them out and seal them properly too.
Who out there has used  silicone and what is your experience? Silicone is 
cheaper and great for house  windows but i dont think it has a place on board 
a boat.  It isnt totally  waterproof and breaks down very fast in a salty, 
warm environment. If you are  bedding hardware you might want to remove in 
the future, perhaps 3M 4200 might  be the way to go.
Lets ask Rummy!
Bob

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting