2015-01-17; 20:18:59 EST
Member Since
2014-05-06
Posts: 3821
My "new" 1986/2006 had recent CB work done by marina in CN. They were supposed to test it in water. I launched boat after bringing it home, sailed it and put it away for night. Next morning, bow was down a foot. After bailing, a friend noticed some of bolts on CB were not tight, causing the leakage. After tightening, most of leak disappeared but just kept leaking like a quart a day. Several rounds of tightening did not cure leak and I stopped, fearing damaging CB plate. Now, several weeks after taking it out of water, I've removed the CB plate and I'm not liking what I'm seeing - appears I should have stopped tightening sooner. I've enclosed 3 pictures, 1 of trunk, 2 of plate - part that seals against rubber. The worst places on plate are near the 1.5 " slot in trunk for the knobs (?) on CB to slide up and down. The FG between bolt hole and slot is very thin and has been damaged - creates a small recessed area rubber might have a problem sealing. My other concern is that the plate is now deformed at each bolt hole and there are stress cracks, some which look like they could let water in. I'm considering prepping area and trying to put down some FG resin to seal recessed area and small stress cracks. So, if you are knowledgeable about this, please take a look at photos let me know your recommendations. IMG_1436.jpg IMG_1441.jpg IMG_1432.jpg Brooks Bridges 1986/2006 Rhodes 22 Cambridge, MD -- View this message in context: http://rhodes-22.1065344.n5.nabble.com/How-bad-is-my-CB-plate-tp49315.html Sent from the Rhodes 22 mailing list archive at Nabble.com.See the original archive post