The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



How bad is my CB plate?

2015-01-17; 22:18:32 EST

Member Since

2014-05-06

Posts: 3821

Brooks...simple solution...first..is your gasket in good condition?, second, do NOT use any sealer, 3. Just drill out each hole in the cb trunk to allow a stainless, 1/4" bolt to pass through. Be sure bolt extends at least 1/2" to 3/4" below trunk flange. Be sure to install washers above and below and snug up each bolt with 1/4" nut. Do this for each bolt, replacing each and every screw. Don't over tighten. 
I had the same problem and actually effected this repair with the boat in the water! The key was to replace only one bolt at a time, tedious and time consuming but a very effective repair. I believe Stan has upgraded all refurbished and new c/b assemblies with this method. Did not leak a drop all season after this happened. I too found water in my cabin above the floor shortly after splashdown and had reworked my c/b in the spring with new blocks and line..but like you, the screws failed to make a tight seal. Bolts and nuts are the key.
Chris Greco
Feel free to call me to discuss if you like. Cell 631-871-6055. I will be in church tomorrow morning but available after 12:30

Sent from my iPad

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting