The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



How bad is my CB plate?

2015-01-18; 19:43:50 EST

Member Since

2014-05-06

Posts: 3821

Graham,
You really need to look closer at his photos. This cap has gel coat.  
Fiberglass does not adhere to gel coat. The areas around the holes have been  
compressed and has damaged the glass and has caused total de lamination. Simple 
 glass work this is not. I downloaded the photos to my computer and then 
zoomed  in on them. The detail tells me this is a real mess. I will guarantee 
that this  cap cannot be repaired with your method. You will have to remove 
all the broken  glass and then be able to sand everything perfectly flat. I 
certainly don't have  that ability and I've been repairing and building 
boats most of my life and I've  been in several R22 centerboard trunks.
 
Rummy
 
 
In a message dated 1/18/2015 3:43:27 P.M. Eastern Standard Time,  
rhodes22-list at rhodes22.org writes:

The nice  thing about fibreglass is that it is really easy to repair -
especially  were a perfect finish is not at stake. Just make sure you remove
all of the  broken bits and any cracks and taper the area around the hole.
Resin will  not penetrate cracks sufficiently to make a strong bond. There
are lots of  YouTube videos about repairing fibreglass that should be very
helpful.  

Here is a video that should make it all  clear:
https://www.youtube.com/watch?v=i9hfpOCnzEs 

Don't despair,  it reall isn't all that difficult and is well within the
ability of just  about anyone. If you screw it up, just do it again.

Graham  



See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting