The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



How bad is my CB plate?

2015-01-18; 20:52:25 EST

Member Since

2014-05-06

Posts: 3821

Graham,  

I have been doing a lot of reading recently on fiberglass repair. And you are correct in regards to making sure the mould release agent is gone,  but the two different authors i have read state that you just have to give the gel coat some teeth to hold the new epoxy.  They suggest sanding lightly with 100 grit paper. 

They both state that extra material should be removed any place that is cracked by grinding it into a shallow 'V'. One recommends using using 'chop' as the material to fill it with then saturated with epoxy. 

The other days that pretty much any fiberglass material will work for fill. 

James

Sent from Yahoo Mail on Android

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting