The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



How bad is my CB plate?

2015-01-18; 21:47:33 EST

Member Since

2014-05-06

Posts: 3821

James:

I agree that epoxy will adhere to clean and roughed up gelcoat. Removing the
gelcoat s probably better to get the teeth of the epoxy into the substrate
but epoxy filler is feathered into gelcoat all the time. 
I am not sure what you mean by "chop" but if this refers to loose fibre then
I can say that I have used it to fill larger voids. I have even used sawdust
with epoxy to fill large non-structural voids. The only thing to watch out
for is using matt to build thickness in layups. Apparently the epoxy just
does not penetrate mat well and you are likely to have small voids in the
lamination and that is not good.

Graham 


See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting