The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



How bad is my CB plate?

2015-01-18; 22:21:56 EST

Member Since

2014-05-06

Posts: 3821

I believe you could repair this problem.  A friend of mine always says "you can make ANYthing out of fiberglass except money!"
The gelcoat must go! If you want a smooth and level surface for your neoprene gasket consider this.  Fill and grind each surface as flat possible.  Fill the holes with resin.  Grind out cracks bigger so the resin can get in there. Any gaps bigger than say 1/4" need a bit of fiberglass cloth stuffed inside.  Sand as smooth as possible the set level, make a little dam all around with tape then pour resin with hardener for a slow set. If properly done this will give a super flat shiny surface.  Do the same with the cap but it is set upside down.  Try not to get the depth of that resin pour more than 1/4". You prob will still have to sand this clear resin layer but you can go up in grit and even polish it smooth with a buffer.

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting