The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



How bad is my CB plate?

2015-01-20; 11:45:38 EST

Member Since

2014-05-06

Posts: 3821

Bob and Richard,

I think a variation on your suggestions is worth a try. I agree it's only
necessary to have  a good seal in the area between the water and a line
drawn roughly along inside edges of the bolt holes. That's the area I'm
concentrating on for assuring smoothness. Again, easy for me to launch and
test. 

I'm reluctant to use 4200 but did have good luck removing a speed transducer
bedded with 4200. My neoprene gasket is still good so may just improve on
grosser spots and try it with no sealant first. 

BTW: 4200/5200 tip: They tell you once you open a tube it lasts like 48
hours. I found putting tube in fridge it lasts for months - at least it
doesn't harden/thicken noticeably.

Brooks Bridges
86/06 R22 "Changes"
Cambridge, MD



--
View this message in context: http://rhodes-22.1065344.n5.nabble.com/How-bad-is-my-CB-plate-tp49315p49346.html
Sent from the Rhodes 22 mailing list archive at Nabble.com.
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting