The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



CB pennant hose replacement.

2015-01-30; 08:23:45 EST

Member Since

2014-05-06

Posts: 3821

For future reference, next time you replace the pennant tube, most people  
use double clamps on each end if there is enough room for them.
 
Rummy
 
 
In a message dated 1/30/2015 6:19:48 A.M. Eastern Standard Time,  
rhodes22-list at rhodes22.org writes:

The hose  segment needed was 16" long.  Placed two stainless hose clamps on 
hose  prior to threading line through. Fiberglass had a cut out to allow a 
small  ratchet access to tighten the upper clamp to the through hull. ( 
Thanks Stan!)  My three year old supervised.  Job rating was: easy and takes 15 
min....  30 minutes with a three year old supervising due to the  
question...Why?

Bob  (palatka)


See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting