> On Jan 30, 2015, at 8:23 AM, The Rhodes 22 Email List <rhodes22-list at rhodes22.org> wrote:
>> For future reference, next time you replace the pennant tube, most people
> use double clamps on each end if there is enough room for them.
>> Rummy
>>> In a message dated 1/30/2015 6:19:48 A.M. Eastern Standard Time,
>rhodes22-list at rhodes22.org writes:
>> The hose segment needed was 16" long. Placed two stainless hose clamps on
> hose prior to threading line through. Fiberglass had a cut out to allow a
> small ratchet access to tighten the upper clamp to the through hull. (
> Thanks Stan!) My three year old supervised. Job rating was: easy and takes 15
> min.... 30 minutes with a three year old supervising due to the
> question...Why?
>> Bob (palatka)
>>> __________________________________________________
> To subscribe/unsubscribe go to
>http://www.rhodes22.org/mailman/listinfo/rhodes22-list>> For the list Charter and help with using the mailing list and archives go
> to http://www.rhodes22.org/list> __________________________________________________
>> __________________________________________________
> To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list>> For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list> __________________________________________________
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.