The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



New Joint of Deck and Hull

2015-02-03; 20:04:05 EST

Member Since

2014-05-06

Posts: 3821

Chuy:

Just a few thoughts and suggestions.

I used fibreglass on the inside of the join but had to cut the lip off the
liner to get in to the area. In my case there was a strip of wood on the
inside of the join that was broken and rotted wherever the water reached it
so I removed it with a chisel. I also wanted to bond the fibreglass to the
deck and hull fibreglass rather than to a weak piece of plywood. Before
applying the fibreglass I filled the join area with epoxy thickened with
high-strength filler to fill any gaps and old holes and to give a smooth
radius for the glass. I used epoxy for everything because of its superior
properties but I am sure polyester would work as well. I used two layers of
6" roving tape but plan to add another two layers later because I have no
idea how many layers are adequate.. (see pictures).

I glassed the joint from the bow to the aft of the cabin at the
companionway. I could not see the need to glass the seam beyond that point
as a bit of water leaking into the cockpit is not a problem and from what I
could see it would be incredibly difficult to get into the area behind the
seats to work on the joint.

I will probably insert bolts after the fibreglass work is completed but
might use rivets. Putting glass over the bolts does not seem like a good
idea to me. I would not use 5200 for the bolts as the day may well come when
you want to remove them again. Nothing is permanent except the mess that
5200 creates. Using 5200 for the area where the deck and hull overlap might
be appropriate but I would be inclined to use the stuff the Rummy used. It
is just my bias, but I have never used 5200 when I didn't eventually regret
it.

If you glass the joint adequately you will need considerably fewer
mechanical fasteners so there will be fewer places for leaks to develop. 

If you also fill the joint with a good sealant I can't see how significant
amounts of water could make its way past the rub rail and through the bolt
holes. I expect that the leaks were primarily through the joint. In my case
the original rivets were aluminium, I think, and there was no rust.

If your boat is anything like mine you will not be able to save and reuse
the old rub rail. When I replace mine I will use the one-piece flexible
vinyl stuff as it looks to be a better product and easier to install.

Good luck,


Graham Stewart
gstewart8 at cogeco.ca
613 389-1737


Hull - Deck join rebuild 2009 (3).jpg

Hull - Deck join rebuild 2009 (4).jpg

Hull - Deck join rebuild 2009 (6).jpg
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting