2015-02-05; 17:45:26 EST
Member Since
2014-05-06
Posts: 3821
Chuy: Good summary and sorry to be part of the confusion. If it helps to sort out he confusing advice, I think that the options of glassing or using 5200 (or equivalent) might not be all that different in the end. They claim that 5200 is as strong as the glass - although that would depend on whether it is applied properly - and using glass would also as strong as the hull and deck if is of sufficient thickness. 5200 is more flexible than glass but with bolts every foot or so, the flex would be minimal, if any, anyway. With glass you should be able to get away with fewer bolts. I consulted with a master boat restoration person on this point who told me I should use a bolt every 4 feet! That seemed very far spaced to me so I will probably use a bolt about every 18" to be safe. If you can get rid of the existing sealant and get a good quantity of the new sealant deep into the join, then go with that option. If you can't get adequate sealant into the join or if it cures faster than you can apply the bolts, or possibly, if you want to avoid removing the rub rail, then you might want to go the route of the glass - providing you have good access to the join on the inside of the boat. Of course, these approaches are not mutually exclusive either. In fact, I plan to use the sealant and more closely-spaced bolts on the back quarter and transom. Either way, I think you will end up with a good and permanent fix. Which method you choose should be guided by the materials you feel most comfortable using and which method offers greatest access to the join rather than be too concerned about which is "better". Just do what you think will be most achievable and feasible under your circumstance. Either way I think the fix will be good and permanent. GrahamSee the original archive post