2015-02-06; 09:04:16 EST
Member Since
2014-05-06
Posts: 3821
Chuy, I'm jumping back into this discussion one last time. I'm not a marine engineer, but have built/rebuilt many boats over the past fifty years. Unless you are building a hull out of steel or concrete, they are going to flex. I would guess that even steel or concrete can flex under certain circumstances. The hull to deck joint of the R22 flexes because of the many varied forces applied to it by the mast, rigging and wave action. Epoxy or fiber glassing the joint will remove the ability of the joint to flex. In fact, I would be willing to bet that over a very short period of time you will find that it will crack and pulverize due to the previously mentioned forces working against it. It would be a monumental chore to separate the joint enough to thoroughly clean it AND remove the gel coat for best adhesion. As I have previously stated, it does not bond well with gel coat. The process to fiberglass the joint would be incredibly labor intensive and in my opinion a waste of time and resources. Why would you want to do this when a very simple and time tested solution has already been put forth on the list. The problems older hulls are experiencing with the joint are due to improper use of materials during original construction. In short, adhesives/caulking have come a long way in forty some years. The one part polyethylene products have a life expectancy of fifteen years with direct exposure to UV rays from the sun. I wonder how long they will last in a covered joint application. Good luck with whatever you do, but remember, removing and repairing a failed fiber glassed joint might be more than anyone would want to undertake, even Mr. Casey. Rummy In a message dated 2/6/2015 1:14:39 A.M. Eastern Standard Time, rhodes22-list at rhodes22.org writes: Hi ALL , I received my special anniversary issue of Sail Magazine early in the week but did not have time to read it., Volume 46 Number 2 February 2015. Tonight I open it to the table of contents and guess what one of the articles was about? Page 60, "Sealed up Tight When is comes to securing the hull to deck, which method is best?" by Don Casey. The author states "Boat builders are increasingly relying on high-strength methacrylate adhesives to fuse the hull to the deck into a single, leak proof component, in some cases omitting mechanical fasteners all together". Further he states that this process is expansive so some builders use flexible adhesives to bond the deck and hull, like 5200. He goes on and states that repairs on the joint are not treated as two halves, since there is no reason to. In most cases the deck to hull repair is done without a joint in the damaged area. The article is very well written and easy to follow. He explains the different hull to deck joints used. Their strengths and weaknesses and the reason to for their use. After reading the article, I think that I most of my ideas with a few minor adjustments. Thanks for all your input. Chuy AfterMath 1987See the original archive post