2015-02-07; 19:48:29 EST
Member Since
2014-05-06
Posts: 3821
Hi Chuy: The postings opposed to the idea of fixing the hull-deck join with fibreglass lay-up were making me increasingly doubt the approach I suggested. However, your reference to Don Casey's article in Sail magazine prompted me to check the subject of hull-deck repairs in Casey's book Sailboat Hull and Deck Repairs that I had read about 4 years ago and had forgotten about. I knew that I had not just dreamt up the idea of joining the hull and deck with fibreglass layup but I could not remember where the idea originated. Casey gives detailed instructions for sealing with 5200 and re-fastening where access to the joint is not feasible. That said, he states the following: "FIBERGLASSING THE BEST SOLUTION FOR A LEAKING HULL-to-deck joint is to join the two parts permanently with fibreglass lay-up. This can be done either inside or outside, depending on access and the design of the joint." (Emphasis is in the original text.) In discussing types of joints, Casey says: "The best joints are fibreglasses together into a single strong and leak-free unit, but few are built this way. Most are joined mechanically with rivets, screws, or bolts and depend on sealant to keep water out." In my case, getting access to the joint involved removing the covering pads (a few screws), cutting back the lip of the liner, and removing the wooden strip below the joint -all tasks that are much easier than removing and replacing the rub rail and all of the hull-deck fasteners. I removed my rub rail because I also had major deck core replacement to do but had that not been the case I would have stayed with the inside glassing alone. At least now I can sleep knowing that I had not lost my mind or ruined the boat. GrahamSee the original archive post