The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



New Joint of Deck and Hull from originator

2015-02-10; 08:59:10 EST

Member Since

2014-05-06

Posts: 3821

Sorry, that was the ABYC standards that I checked - not ABYA. See:
https://www.abycinc.org/standards/toc.cfm 
I can find no standard that deals with the hull-deck joint. Section H-27 is
described as follows:

"H-27 - Seacocks, Thru-Hull Fittings, and Drain Plugs
This standard is a guide for the selection of materials, design,
construction, and installation of seacocks, thru-hull connections, drain
plugs, and other fittings that penetrate the hull at or below the
maximum-heeled waterline."

They only publish the standards table of contents on line and each separate
standard has to be purchased so I can't be certain that the matter isn't
dealt with in a standard but not mentioned in the table of contents, but
that would seem unlikely to me.

The hull-deck join is already the most rigid part of the boat when sealant,
fasteners and rub rail are used - not to mention the doubling up of the
laminations with the overlap of hull and deck. It seems to me that any
transfer of stress is already occurring.


Graham 

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting