The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Permission to come aboard?

2015-03-29; 15:55:35 EDT

Member Since

2014-05-06

Posts: 3821

Jefferson:
You can use a porta-pottie on Ontario waters so long as it is fixed in place
and has a deck pump out. Most porta-potties have kits for this purpose. No
need for a separate holding tank.

You would be most welcome if you make the trip to my place and can tie up at
my dock given that my boat is still on the hard. I also have a mooring that
you can use. I am located just west of Lemoines Point on the north Shore of
Lake Ontario.

The Rhodes 22 were built under contract with 3rd parties in 1976 and as a
result some of the construction details were lacking. A few things that you
might want to check on the boat that might cause problems.  

- The transom rings were installed without nuts on the inside,
- the deck leaked where the air vent for the holding tank went through the
deck at the front - you may not have one if you don't have a holding tank
but that is a prime spot for water to make its way into the core.. The
softness that my deck developed when walked on was not due to rot as I
suspected but was because the deck skin simply separated from the core,
There was minimal sealant used to join the two surfaces and it simply let
go. That is actually good news as it is possible to reattach the core by
injecting epoxy under the skin rather than having to remove the deck and
replace the core. I discovered this the hard way.
- The keel on my boat split open at the bottom of the keel at the
centreboard slot. I could only see it  by laying flat on my back right under
the keel - a position I rarely found myself in. The sharp corner seems to be
the weakest point. Of course you might well not have that problem and I have
no idea why it developed in mine, but by the time I realized that I had this
problem it was probably years from the time it started and a crack had
spread all the way around the centreboard opening. I only noticed the
problem when I saw some of the internal filling hanging from the keel.  I
suspect that some water got into the keel and froze. I discovered that there
were large voids in the keel where water could collect in substantial volume
if it found its way in. It took 3 gallons of resin to fill the voids that I
was able to find. My advice is to check it out before you launch. You
probably will not have that problem but given that our boats were built so
close together and potentially by the same builder it might be a reasonably
prudent examination to make.
- The cap on my centreboard housing had been installed with a layer of
fibreglass over it and the flange sealed with something like 3M 5200. I
suspect that might have been a repair done by a subsequent owner but I can't
be sure. It was a pain to remove the cap and impossible to do so without
badly damaging it.
- When I removed the bottom paint last summer I discovered that the gelcoat
and even the substrate of the hull was damaged where the boat sat against
the front struts of the trailer. Fortunately it isn't difficult to fix and
the repair is ultimately covered by the bottom paint. I would look carefully
in that area especially if you remove the existing paint. I repaired the
glass by grinding out the damaged areas and replacing with multiple layers
of cloth and epoxy. I plan to add some reinforcement to the inside of the
hull this summer - particularly in that region as the fibreglass is thin
there and dents badly on the trailer. Newer boats were built with thicker
hulls to address that problem.

Just because I had these problems does not mean that any of them will apply
to you. But they did seem to me to be weak spots and you might be reassured
to know they aren't a problem in your case.

Take care,

Graham Stewart

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting