< prior
Back to Month
Go to Thread
2015-03-31; 12:59:00 EDT
Member Since
2014-05-06
Posts: 3821
Hi Graham - thanks for clarifying the porta-potti issue. And for the invitation! I didn't realize 76's were built by 3rd parties. That's unsettling. I will check out my keel, bearing in mind the problems you have had. And the other flaws you detected. Much appreciated, JeffersonSee the original archive post
On 15-03-29 3:55 PM, "The Rhodes 22 Email List" <rhodes22-list at rhodes22.org> wrote: >Jefferson: >You can use a porta-pottie on Ontario waters so long as it is fixed in >place >and has a deck pump out. Most porta-potties have kits for this purpose. No >need for a separate holding tank. > >You would be most welcome if you make the trip to my place and can tie up >at >my dock given that my boat is still on the hard. I also have a mooring >that >you can use. I am located just west of Lemoines Point on the north Shore >of >Lake Ontario. > >The Rhodes 22 were built under contract with 3rd parties in 1976 and as a >result some of the construction details were lacking. A few things that >you >might want to check on the boat that might cause problems. > >- The transom rings were installed without nuts on the inside, >- the deck leaked where the air vent for the holding tank went through the >deck at the front - you may not have one if you don't have a holding tank >but that is a prime spot for water to make its way into the core.. The >softness that my deck developed when walked on was not due to rot as I >suspected but was because the deck skin simply separated from the core, >There was minimal sealant used to join the two surfaces and it simply let >go. That is actually good news as it is possible to reattach the core by >injecting epoxy under the skin rather than having to remove the deck and >replace the core. I discovered this the hard way. >- The keel on my boat split open at the bottom of the keel at the >centreboard slot. I could only see it by laying flat on my back right >under >the keel - a position I rarely found myself in. The sharp corner seems to >be >the weakest point. Of course you might well not have that problem and I >have >no idea why it developed in mine, but by the time I realized that I had >this >problem it was probably years from the time it started and a crack had >spread all the way around the centreboard opening. I only noticed the >problem when I saw some of the internal filling hanging from the keel. I >suspect that some water got into the keel and froze. I discovered that >there >were large voids in the keel where water could collect in substantial >volume >if it found its way in. It took 3 gallons of resin to fill the voids that >I >was able to find. My advice is to check it out before you launch. You >probably will not have that problem but given that our boats were built so >close together and potentially by the same builder it might be a >reasonably >prudent examination to make. >- The cap on my centreboard housing had been installed with a layer of >fibreglass over it and the flange sealed with something like 3M 5200. I >suspect that might have been a repair done by a subsequent owner but I >can't >be sure. It was a pain to remove the cap and impossible to do so without >badly damaging it. >- When I removed the bottom paint last summer I discovered that the >gelcoat >and even the substrate of the hull was damaged where the boat sat against >the front struts of the trailer. Fortunately it isn't difficult to fix and >the repair is ultimately covered by the bottom paint. I would look >carefully >in that area especially if you remove the existing paint. I repaired the >glass by grinding out the damaged areas and replacing with multiple layers >of cloth and epoxy. I plan to add some reinforcement to the inside of the >hull this summer - particularly in that region as the fibreglass is thin >there and dents badly on the trailer. Newer boats were built with thicker >hulls to address that problem. > >Just because I had these problems does not mean that any of them will >apply >to you. But they did seem to me to be weak spots and you might be >reassured >to know they aren't a problem in your case. > >Take care, > >Graham Stewart > >-----Original Message----- >From: rhodes22-list-bounces at rhodes22.org >[mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 >Email >List >Sent: March-29-15 1:02 PM >To: The Rhodes 22 Email List >Subject: Re: [Rhodes22-list] Permission to come aboard? > >Hi Graham, > >Thank you for the welcome. I'm gobsmacked there are only two Rhodes in the >whole country. Throw a rock in any marina and you'll hit a Catalina 22 - a >very inferior design to the Rhodes to my mind. > >My sympathies for your major restoration. I have neither the skills nor >the >patience and am praying that my hull is sound. But it is good to know >someone out there knows. I went to Queen's U and know Bath well. Beautiful >country, and great sailing around Kingston. I'd love to trailer my boat up >there - going up the Richelieu from Lake Champlain and then up through the >endless locks to Lake Ontario is something I have done once and don't need >to do again! But I read somewhere that porta-potties are forbidden on >Ontario lakes so I'd have to plumb in a head and holding tank or risk >getting busted. > >I pulled the tarp off Patience this morning and sat in the cabin taking >stock until my feet froze. Bring on Spring! > >Jefferson > >On 15-03-28 12:28 PM, "The Rhodes 22 Email List" ><rhodes22-list at rhodes22.org> wrote: > >>Jefferson: >>I am very excited to see that there may now be two Rhodes 22 boats in >>Canada. Welcome. >> >>My boat, Agile, is hull number GBX220052G76 making mine a 1976 as well. >>The >>number on the sail is 244. Your boat was built in May and mine in July >>of that year so they should be almost identical. I have been doing a >>major restoration and in the process have dissected almost every part >>of the boat so if you need to know more about what is under the skin of >>the boat I should be able to tell you. I am located on Lake Ontario at >>Kinston. >> >>Here is to great sailing. >> >>Graham >> >> >>-----Original Message----- >>From: rhodes22-list-bounces at rhodes22.org >>[mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 >>Email List >>Sent: March-28-15 10:21 AM >>To: rhodes22-list at rhodes22.org >>Subject: [Rhodes22-list] Permission to come aboard? >> >> >>I am the new owner of a '76 Rhodes, hull number GBX220092E76. Despite >>my admiration for the beauty and ingenuity of the boat's design I would >>likely not have dared to make the jump if I hadn't discovered this site >>and the generosity and patience of its contributors. I feel honoured to >>join your ranks. >> >>About me: I grew up in a sailing family. Back in the dawn of time when >>dinosaurs roamed the earth we sailed 14' Ackroyd dinghies, then Rhodes >>Bantams, and on to Lightnings and Flying Dutchmen and most recently >>Flying Scots. I discovered cruising when a good friend bought a >>Catalina 25, and promptly came down with 2 foot-itis - 25 became a >>Catalina 27, then a Columbia 31 and finally a Mirage 26. We sailed on >>Lake >Ontario, up the St. >>Lawrence River past Quebec City, and all over Lake Champlain - which is >>really an inland sea 100 miles long and up to 10 miles wide in places. >> >>Then he sold the Mirage, and I thought well hell, now what am I going >>to do? >>After a lot of looking, I came across the Rhodes and fell in love. >> >>The boat: named "Patience," which feels quite appropriate consider how >>long I looked for it. Among the papers inherited from the previous >>owner is the yellowed but legible order sheet for the boat in 1976, >>from GBC in Irvington-on-Hudson. With all the options the original >>owner chose the bill for a brand spanking new Rhodes Continental came >>to $8,095. The second owner bought the boat in the early '80's andy >>sailed it on the Ottawa River, and then 22 years ago, so he told me, >>they bought a cottage on a lake too small for sailing and it has >>remained on its trailer under cover ever since. >>I did a pretty thorough inspection with someone more experienced than >>I, and it seems to be in pretty good shape. All original, including >>cushion covers, the icebox, porta-potty and two burner alcohol stove >>that was standard on RC models in '76. It is equipped with a 150 >>genoa. The work it needs seems to be mostly cosmetic, aside from >>running rigging which needs to be updated, and if it doesn't sink to >>the bottom on launch day I'll be delighted. >> >>I'm going to moor it on Lake Memphremagog this summer while I work on >>it, and then on Lake Champlain. I plan to send 10% of the price I paid >>to Stan, which isn't going to thrill him since I didn't pay much, and >>in Canadian dollars, but seems the right thing to do anyway. I'm not >>sure what I'll be able to afford to buy from General Boats, given the >>current exchange rates and my own budget. But it will be my first stop >>when I go shopping. >> >>So that's me and Patience, slowly emerging from the melting snow. I >>have about six million questions but will try not to test your >>patience. I can't download any attachments with "Old Nabble" in the >>address, and if anyone could enlighten me I will continue to scour the >>archives for answers. >> >>Jefferson Lewis >> >> >> >> >> >> >>__________________________________________________ >>To subscribe/unsubscribe go to >>http://www.rhodes22.org/mailman/listinfo/rhodes22-list >> >>For the list Charter and help with using the mailing list and archives go >>to >>http://www.rhodes22.org/list >>__________________________________________________ >> >> > > > >__________________________________________________ >To subscribe/unsubscribe go to >http://www.rhodes22.org/mailman/listinfo/rhodes22-list > >For the list Charter and help with using the mailing list and archives go >to >http://www.rhodes22.org/list >__________________________________________________ > >
To use your email application to send a messsage to the webmaster rather than this form, .
Your post is being sent... 