The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Permission to come aboard?

2015-04-01; 13:31:41 EDT

Member Since

2014-05-06

Posts: 3821

Graham:
Ok.  I didnt add the extra ballast.  It had it already.  I called it "extra" since i consider needing to add internal ballast a design flaw or a building shortcut (i.e. Concrete instead of lead). But hey i am not criticizing the boat, just explaining my word choice. 

Yes i too am adding LIMBER HOLES too.  At 4 am i woke up remembering that i called them "stringer scuppers" yesterday which isnt nautically correct! Hahaha!

For the main center floor stringers i cut them from 2x6" pressure treated lumber.  The wider area will make adding the floor and bilge inspection hatch easier and acually was cheaper than 5/4" deck wood.

I am still deciding what to do about my hull/deck joint.  Access is good from inside at this point. I found these great caulk gun tubes of two part epoxy that mix as you pump it that i should be able to use to easily fill the joint.  We will see!  The other option is the Np-1 Rummy recommended.

I think that there is also a fair amount of water that finds its way into the bilge from condensation.  I am designing a solar powered bilge dryer.  Another "we will see"

Another idea is that i am adding floor vents to keep air moving under the floor boards and to allow the bilge to dry.

Bob (palatka)

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting