2015-04-11; 09:26:08 EDT
Member Since
2014-05-06
Posts: 3821
Hi All, Been off the list getting boat ready and launched here in Cambridge, MD. Last Fall I launched my '86/2006 newly purchased R22, sailed it, put away for night, returned next morning to find water up to cushions in V-berth. Improperly installed CB cap was culprit and appears I've fixed it - see a little water on rubber gasket but no accumulation in bilge. Water seems to be less all the time. (After launch, I had to tighten several bolts quite a bit more so think path for water created while loose.) As I'm looking at solar charger mounted on FG flotation area the V-berth cushions sit on, I noticed "historic" mounting holes in tank that could have let water into this forward flotation. Can't be much but would like to look. Boat is ever so slightly bow down (I think) but right now have 80 lb less on stern (trolling motor vs 9.8 4-cycle). I don't see any inspection port. Any ideas? One thought: Drill small holes front and back and push a pointy wooden dowel down till it stops and look for dampness. I'll choose a hole size easily plugged. Brooks Cambridge MD "Changes" -- View this message in context: http://rhodes-22.1065344.n5.nabble.com/Inspecting-V-berth-area-for-water-tp49720.html Sent from the Rhodes 22 mailing list archive at Nabble.com.See the original archive post