The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Inspecting V-berth area for water

2015-04-11; 11:28:20 EDT

Member Since

2014-05-06

Posts: 3821

Brooks:
Given you experience with the leaking gasket and the fact that there is
still some minor leakage after tightening the bolts, I think I would be
inclined to take the cap off, reform the gasket, check for smooth matching
surfaces and then reinstall. I don't think it should take excessive pressure
on the bolts to stop leakage nor would that be desirable, and I would worry
that even a small amount of leakage might increase with time. The fact that
it leaked badly at one point raises the possibility that foreign material is
lodged in the joint and as it decomposes the leak might intensify.

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting