The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Cabin Roof Plate

2015-05-04; 10:30:10 EDT

Member Since

2014-05-06

Posts: 3821

Christopher,

I would drill out the holes you are going to make for the screws twice as wide and the teeth of the screws, then back fill the holes with Epoxy.  Once that is dry, sand it flush with the deck and drill pilot holes into the epoxy for the new screws.

This way there is no direct path from the screw to the core material and you don't end up with a soft deck like I have.  Lots of people try to depend on the surface sealants between the plate and the deck, but the work that happens at the screw/plate/deck area will create an opening to the core where water can seep.  By drilling out a hole twice as wide as the screws teeth, you gain a water proof buffer between the screws and the water absorbing core material.

James Nichols

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting