The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Cabin Roof Plate

2015-05-04; 11:31:12 EDT

Member Since

2014-05-06

Posts: 3821

Just to add to the comments of others, I would enlarge the hole and then use straight epoxy without filler first to soak into and seal any core material. After a few minutes and before the epoxy sets, remove any that remains in the hole and then add epoxy mixed with cabosil filler rather than the high density filler as that mixture is too thick. If it is too thick you may create voids so leave the mixture very sloppy so it will still flow into the hole. Re drill the holes once the epoxy sets but before it completely cures as it is much easier to drill out then. Once cured, the epoxy is much harder than the surrounding material and it can be difficult to keep the drill bit cantered where you want it. Brad point drills also help. I would not use 5200 as it is too permanent. The screws should hold it in place and the epoxy will protect the core.

Graham 


See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting