< prior
Back to Month
Go to Thread
2015-05-07; 21:36:41 EDT
Member Since
2014-05-06
Posts: 3821
Living a little dangerously with that reconditioned heart aren't you?? Charles s/v Daydreams 98 R 22See the original archive post
> On May 7, 2015, at 6:39 PM, The Rhodes 22 Email List <rhodes22-list at rhodes22.org> wrote: > > Rick, > And Stan is always right? Don't you believe it. > Now ducking for cover. > > Rummy > > > In a message dated 5/7/2015 4:41:52 P.M. Eastern Daylight Time, > rhodes22-list at rhodes22.org writes: > > Rummy, > > I've tried epoxy. It holds the screws too tight for tear-out, resulting in > major gelcoat damage. Stan's instructions for the deck crane block specify > 3M 4200. And that seals just fine. > > Rick > > On Thu, May 7, 2015 at 3:27 PM, The Rhodes 22 Email List < > rhodes22-list at rhodes22.org> wrote: > >> Rick, >> I'm, sorry, but I disagree. You must fill the holes with epoxy for > strength >> and also to seal the area from water penetration. 4200 should not be > used. >> >> Rummy >> >> >> In a message dated 5/4/2015 11:31:01 A.M. Eastern Daylight Time, >> rhodes22-list at rhodes22.org writes: >> >> Filling the larger holes with epoxy would be very risky. The next time >> you >> over stress the plate, the epoxy plugs plus gelcoat will tear out. It >> would be better to fill with 3M 4200. >> >> Rick >> >> On Mon, May 4, 2015 at 10:59 AM, The Rhodes 22 Email List < >> rhodes22-list at rhodes22.org> wrote: >> >>> Thanks. My blunder is limited to the Cabin Roof Plate, so far, that > the >>> hoist crane attaches to and your advice to drill out the screw holes >> and >>> fill with epoxy sound good. >>> >>> Details: >>> >>> READ THE INSTRUCTIONS! Ok, I have had my boat for five years and had >> the >>> mast up and down a few times so I figured this would be a 20 minute >>> exercise to lower the mast for some mast top maintenance. The mast >> crane >>> that came with my boat has a bale on it to connect the line with >> shackles >>> to the bale on the mast. The crane currently on my boat was > apparently >>> replaced during a visit to the plant with a different crane that does >> not >>> have a bale rather two connection points for the turnbuckles of the > two >> aft >>> lower shrouds. I have never lowered the mast with the shroud method >> before >>> so I simply clipped one end of the line with shackles to the bow cleat >> and >>> the other end to the crane and then connected the crane line to the > mast >>> bale. That is backwards from the instructions I failed to read. The >> mast >>> came down but pulled the crane base plate out of the cabin top and the >> mast >>> decided to go 45 degrees to port. I managed to pull the mast back to >>> center and lower it then realized two more blunders. I remembered to >>> disconnect the sliding hatch but failed to close the hatch and failed > to >>> move the slider up the mast. My sliding hatch now has some crunched >>> fiberglass to remind me to close the hatch next time. The final error >> was >>> not having sufficient length in the lower forward shrouds that get the >>> chains. Wrong chain position and or not having the turnbuckle open >>> enough. The result was some very tight shrouds that bent the top of > the >>> chain plates. So after five years of boating without any major screw >> ups I >>> suppose this makes me an official Rhodie! >>> >>> Christopher P. Cowie >>> >>> 4400 MacArthur Blvd, NW >>> Suite 300 >>> Washington, DC 20007 >>> 202.342.2711 ex.204 ? 202.342.2691 fax ? 202.270.1470 mobile >>> [ccowie at cowieassociates.com] >>> >>> >>> Please consider the environment before printing this email. >>> >>> -----Original Message----- >>> From: rhodes22-list-bounces at rhodes22.org [mailto: >>> rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 Email >> List >>> Sent: Monday, May 04, 2015 10:30 AM >>> To: 'The Rhodes 22 Email List' >>> Subject: Re: [Rhodes22-list] Cabin Roof Plate >>> >>> Christopher, >>> >>> I would drill out the holes you are going to make for the screws > twice >> as >>> wide and the teeth of the screws, then back fill the holes with Epoxy. >>> Once that is dry, sand it flush with the deck and drill pilot holes > into >>> the epoxy for the new screws. >>> >>> This way there is no direct path from the screw to the core material > and >>> you don't end up with a soft deck like I have. Lots of people try to >>> depend on the surface sealants between the plate and the deck, but the >> work >>> that happens at the screw/plate/deck area will create an opening to > the >>> core where water can seep. By drilling out a hole twice as wide as > the >>> screws teeth, you gain a water proof buffer between the screws and the >>> water absorbing core material. >>> >>> James Nichols >>> >>> -----Original Message----- >>> From: rhodes22-list-bounces at rhodes22.org [mailto: >>> rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 Email >> List >>> Sent: Monday, May 4, 2015 9:12 AM >>> To: rhodes22-list at rhodes22.org >>> Subject: [Rhodes22-list] Cabin Roof Plate >>> >>> I managed to rip the cabin roof plate, used to connect the mast hoist >>> crane, off my boat yesterday, don't ask how, and I need to > reinstall. I >>> understand that this plate can be screwed to the cabin top or thru >> bolted. >>> I prefer to try and make the repair with the screws. I will use 3M > 5200 >>> Polyurethane Adhesive/Sealant from the plate to the cabin top. My >> question >>> is what I should fill the two screw holes with to re insert the > screws? >> I >>> assume this should be the West System #404 High Density Filler that > can >> be >>> injected into the striped screw holes and then re drill two 3/16" > pilot >>> holes once it has dried. Does this seem like to correct repair? >>> >>> >>> >>> ----- >>> Christopher P. Cowie >>> >>> 4400 MacArthur Blvd, NW >>> Suite 300 >>> Washington, DC 20007 >>> 202.342.2711 ex.204 ? 202.342.2691 fax ? 202.270.1470 mobile [ >>> ccowie at cowieassociates.com] >>> >>> >>> >>> -- >>> View this message in context: >>> http://rhodes-22.1065344.n5.nabble.com/Cabin-Roof-Plate-tp49793.html >>> Sent from the Rhodes 22 mailing list archive at Nabble.com. >>> >>> __________________________________________________ >>> To subscribe/unsubscribe go to >>> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >>> >>> For the list Charter and help with using the mailing list and > archives >> go >>> to http://www.rhodes22.org/list >>> __________________________________________________ >>> >>> >>> __________________________________________________ >>> To subscribe/unsubscribe go to >>> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >>> >>> For the list Charter and help with using the mailing list and > archives >> go >>> to http://www.rhodes22.org/list >>> __________________________________________________ >>> >>> __________________________________________________ >>> To subscribe/unsubscribe go to >>> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >>> >>> For the list Charter and help with using the mailing list and > archives >> go >>> to http://www.rhodes22.org/list >>> __________________________________________________ >> __________________________________________________ >> To subscribe/unsubscribe go to >> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >> >> For the list Charter and help with using the mailing list and archives > go >> to http://www.rhodes22.org/list >> __________________________________________________ >> >> __________________________________________________ >> To subscribe/unsubscribe go to >> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >> >> For the list Charter and help with using the mailing list and archives go >> to http://www.rhodes22.org/list >> __________________________________________________ > __________________________________________________ > To subscribe/unsubscribe go to > http://www.rhodes22.org/mailman/listinfo/rhodes22-list > > For the list Charter and help with using the mailing list and archives go > to http://www.rhodes22.org/list > __________________________________________________ > > __________________________________________________ > To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list > > For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list > __________________________________________________
To use your email application to send a messsage to the webmaster rather than this form, .
Your post is being sent... 