< prior
Back to Month
Go to Thread
2015-05-07; 22:02:24 EDT
Member Since
2014-05-06
Posts: 3821
It is blasphemy. Call the grand inquisitor. RonSee the original archive post
> On May 7, 2015, at 20:36, The Rhodes 22 Email List <rhodes22-list at rhodes22.org> wrote: > > Living a little dangerously with that reconditioned heart aren't you?? > > > Charles > s/v Daydreams > 98 R 22 > >> On May 7, 2015, at 6:39 PM, The Rhodes 22 Email List <rhodes22-list at rhodes22.org> wrote: >> >> Rick, >> And Stan is always right? Don't you believe it. >> Now ducking for cover. >> >> Rummy >> >> >> In a message dated 5/7/2015 4:41:52 P.M. Eastern Daylight Time, >> rhodes22-list at rhodes22.org writes: >> >> Rummy, >> >> I've tried epoxy. It holds the screws too tight for tear-out, resulting in >> major gelcoat damage. Stan's instructions for the deck crane block specify >> 3M 4200. And that seals just fine. >> >> Rick >> >> On Thu, May 7, 2015 at 3:27 PM, The Rhodes 22 Email List < >> rhodes22-list at rhodes22.org> wrote: >> >>> Rick, >>> I'm, sorry, but I disagree. You must fill the holes with epoxy for >> strength >>> and also to seal the area from water penetration. 4200 should not be >> used. >>> >>> Rummy >>> >>> >>> In a message dated 5/4/2015 11:31:01 A.M. Eastern Daylight Time, >>> rhodes22-list at rhodes22.org writes: >>> >>> Filling the larger holes with epoxy would be very risky. The next time >>> you >>> over stress the plate, the epoxy plugs plus gelcoat will tear out. It >>> would be better to fill with 3M 4200. >>> >>> Rick >>> >>> On Mon, May 4, 2015 at 10:59 AM, The Rhodes 22 Email List < >>> rhodes22-list at rhodes22.org> wrote: >>> >>>> Thanks. My blunder is limited to the Cabin Roof Plate, so far, that >> the >>>> hoist crane attaches to and your advice to drill out the screw holes >>> and >>>> fill with epoxy sound good. >>>> >>>> Details: >>>> >>>> READ THE INSTRUCTIONS! Ok, I have had my boat for five years and had >>> the >>>> mast up and down a few times so I figured this would be a 20 minute >>>> exercise to lower the mast for some mast top maintenance. The mast >>> crane >>>> that came with my boat has a bale on it to connect the line with >>> shackles >>>> to the bale on the mast. The crane currently on my boat was >> apparently >>>> replaced during a visit to the plant with a different crane that does >>> not >>>> have a bale rather two connection points for the turnbuckles of the >> two >>> aft >>>> lower shrouds. I have never lowered the mast with the shroud method >>> before >>>> so I simply clipped one end of the line with shackles to the bow cleat >>> and >>>> the other end to the crane and then connected the crane line to the >> mast >>>> bale. That is backwards from the instructions I failed to read. The >>> mast >>>> came down but pulled the crane base plate out of the cabin top and the >>> mast >>>> decided to go 45 degrees to port. I managed to pull the mast back to >>>> center and lower it then realized two more blunders. I remembered to >>>> disconnect the sliding hatch but failed to close the hatch and failed >> to >>>> move the slider up the mast. My sliding hatch now has some crunched >>>> fiberglass to remind me to close the hatch next time. The final error >>> was >>>> not having sufficient length in the lower forward shrouds that get the >>>> chains. Wrong chain position and or not having the turnbuckle open >>>> enough. The result was some very tight shrouds that bent the top of >> the >>>> chain plates. So after five years of boating without any major screw >>> ups I >>>> suppose this makes me an official Rhodie! >>>> >>>> Christopher P. Cowie >>>> >>>> 4400 MacArthur Blvd, NW >>>> Suite 300 >>>> Washington, DC 20007 >>>> 202.342.2711 ex.204 ? 202.342.2691 fax ? 202.270.1470 mobile >>>> [ccowie at cowieassociates.com] >>>> >>>> >>>> Please consider the environment before printing this email. >>>> >>>> -----Original Message----- >>>> From: rhodes22-list-bounces at rhodes22.org [mailto: >>>> rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 Email >>> List >>>> Sent: Monday, May 04, 2015 10:30 AM >>>> To: 'The Rhodes 22 Email List' >>>> Subject: Re: [Rhodes22-list] Cabin Roof Plate >>>> >>>> Christopher, >>>> >>>> I would drill out the holes you are going to make for the screws >> twice >>> as >>>> wide and the teeth of the screws, then back fill the holes with Epoxy. >>>> Once that is dry, sand it flush with the deck and drill pilot holes >> into >>>> the epoxy for the new screws. >>>> >>>> This way there is no direct path from the screw to the core material >> and >>>> you don't end up with a soft deck like I have. Lots of people try to >>>> depend on the surface sealants between the plate and the deck, but the >>> work >>>> that happens at the screw/plate/deck area will create an opening to >> the >>>> core where water can seep. By drilling out a hole twice as wide as >> the >>>> screws teeth, you gain a water proof buffer between the screws and the >>>> water absorbing core material. >>>> >>>> James Nichols >>>> >>>> -----Original Message----- >>>> From: rhodes22-list-bounces at rhodes22.org [mailto: >>>> rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 Email >>> List >>>> Sent: Monday, May 4, 2015 9:12 AM >>>> To: rhodes22-list at rhodes22.org >>>> Subject: [Rhodes22-list] Cabin Roof Plate >>>> >>>> I managed to rip the cabin roof plate, used to connect the mast hoist >>>> crane, off my boat yesterday, don't ask how, and I need to >> reinstall. I >>>> understand that this plate can be screwed to the cabin top or thru >>> bolted. >>>> I prefer to try and make the repair with the screws. I will use 3M >> 5200 >>>> Polyurethane Adhesive/Sealant from the plate to the cabin top. My >>> question >>>> is what I should fill the two screw holes with to re insert the >> screws? >>> I >>>> assume this should be the West System #404 High Density Filler that >> can >>> be >>>> injected into the striped screw holes and then re drill two 3/16" >> pilot >>>> holes once it has dried. Does this seem like to correct repair? >>>> >>>> >>>> >>>> ----- >>>> Christopher P. Cowie >>>> >>>> 4400 MacArthur Blvd, NW >>>> Suite 300 >>>> Washington, DC 20007 >>>> 202.342.2711 ex.204 ? 202.342.2691 fax ? 202.270.1470 mobile [ >>>> ccowie at cowieassociates.com] >>>> >>>> >>>> >>>> -- >>>> View this message in context: >>>> http://rhodes-22.1065344.n5.nabble.com/Cabin-Roof-Plate-tp49793.html >>>> Sent from the Rhodes 22 mailing list archive at Nabble.com. >>>> >>>> __________________________________________________ >>>> To subscribe/unsubscribe go to >>>> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >>>> >>>> For the list Charter and help with using the mailing list and >> archives >>> go >>>> to http://www.rhodes22.org/list >>>> __________________________________________________ >>>> >>>> >>>> __________________________________________________ >>>> To subscribe/unsubscribe go to >>>> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >>>> >>>> For the list Charter and help with using the mailing list and >> archives >>> go >>>> to http://www.rhodes22.org/list >>>> __________________________________________________ >>>> >>>> __________________________________________________ >>>> To subscribe/unsubscribe go to >>>> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >>>> >>>> For the list Charter and help with using the mailing list and >> archives >>> go >>>> to http://www.rhodes22.org/list >>>> __________________________________________________ >>> __________________________________________________ >>> To subscribe/unsubscribe go to >>> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >>> >>> For the list Charter and help with using the mailing list and archives >> go >>> to http://www.rhodes22.org/list >>> __________________________________________________ >>> >>> __________________________________________________ >>> To subscribe/unsubscribe go to >>> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >>> >>> For the list Charter and help with using the mailing list and archives go >>> to http://www.rhodes22.org/list >>> __________________________________________________ >> __________________________________________________ >> To subscribe/unsubscribe go to >> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >> >> For the list Charter and help with using the mailing list and archives go >> to http://www.rhodes22.org/list >> __________________________________________________ >> >> __________________________________________________ >> To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list >> >> For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list >> __________________________________________________ > > __________________________________________________ > To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list > > For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list > __________________________________________________
To use your email application to send a messsage to the webmaster rather than this form, .
Your post is being sent... 