< prior
Back to Month
Go to Thread
2015-05-08; 11:24:38 EDT
Member Since
2014-05-06
Posts: 3821
Rummy, You're about to be burned at the stake, or mast. So you better run, or swim. RickSee the original archive post
On Thu, May 7, 2015 at 7:38 PM, The Rhodes 22 Email List < rhodes22-list at rhodes22.org> wrote: > Rick, > And Stan is always right? Don't you believe it. > Now ducking for cover. > > Rummy > > > In a message dated 5/7/2015 4:41:52 P.M. Eastern Daylight Time, > rhodes22-list at rhodes22.org writes: > > Rummy, > > I've tried epoxy. It holds the screws too tight for tear-out, resulting > in > major gelcoat damage. Stan's instructions for the deck crane block > specify > 3M 4200. And that seals just fine. > > Rick > > On Thu, May 7, 2015 at 3:27 PM, The Rhodes 22 Email List < > rhodes22-list at rhodes22.org> wrote: > > > Rick, > > I'm, sorry, but I disagree. You must fill the holes with epoxy for > strength > > and also to seal the area from water penetration. 4200 should not be > used. > > > > Rummy > > > > > > In a message dated 5/4/2015 11:31:01 A.M. Eastern Daylight Time, > > rhodes22-list at rhodes22.org writes: > > > > Filling the larger holes with epoxy would be very risky. The next time > > you > > over stress the plate, the epoxy plugs plus gelcoat will tear out. It > > would be better to fill with 3M 4200. > > > > Rick > > > > On Mon, May 4, 2015 at 10:59 AM, The Rhodes 22 Email List < > > rhodes22-list at rhodes22.org> wrote: > > > > > Thanks. My blunder is limited to the Cabin Roof Plate, so far, that > the > > > hoist crane attaches to and your advice to drill out the screw holes > > and > > > fill with epoxy sound good. > > > > > > Details: > > > > > > READ THE INSTRUCTIONS! Ok, I have had my boat for five years and had > > the > > > mast up and down a few times so I figured this would be a 20 minute > > > exercise to lower the mast for some mast top maintenance. The mast > > crane > > > that came with my boat has a bale on it to connect the line with > > shackles > > > to the bale on the mast. The crane currently on my boat was > apparently > > > replaced during a visit to the plant with a different crane that > does > > not > > > have a bale rather two connection points for the turnbuckles of the > two > > aft > > > lower shrouds. I have never lowered the mast with the shroud method > > before > > > so I simply clipped one end of the line with shackles to the bow > cleat > > and > > > the other end to the crane and then connected the crane line to the > mast > > > bale. That is backwards from the instructions I failed to read. The > > mast > > > came down but pulled the crane base plate out of the cabin top and > the > > mast > > > decided to go 45 degrees to port. I managed to pull the mast back to > > > center and lower it then realized two more blunders. I remembered to > > > disconnect the sliding hatch but failed to close the hatch and failed > to > > > move the slider up the mast. My sliding hatch now has some crunched > > > fiberglass to remind me to close the hatch next time. The final > error > > was > > > not having sufficient length in the lower forward shrouds that get > the > > > chains. Wrong chain position and or not having the turnbuckle open > > > enough. The result was some very tight shrouds that bent the top of > the > > > chain plates. So after five years of boating without any major screw > > ups I > > > suppose this makes me an official Rhodie! > > > > > > Christopher P. Cowie > > > > > > 4400 MacArthur Blvd, NW > > > Suite 300 > > > Washington, DC 20007 > > > 202.342.2711 ex.204 ? 202.342.2691 fax ? 202.270.1470 mobile > > > [ccowie at cowieassociates.com] > > > > > > > > > Please consider the environment before printing this email. > > > > > > -----Original Message----- > > > From: rhodes22-list-bounces at rhodes22.org [mailto: > > > rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 Email > > List > > > Sent: Monday, May 04, 2015 10:30 AM > > > To: 'The Rhodes 22 Email List' > > > Subject: Re: [Rhodes22-list] Cabin Roof Plate > > > > > > Christopher, > > > > > > I would drill out the holes you are going to make for the screws > twice > > as > > > wide and the teeth of the screws, then back fill the holes with > Epoxy. > > > Once that is dry, sand it flush with the deck and drill pilot holes > into > > > the epoxy for the new screws. > > > > > > This way there is no direct path from the screw to the core material > and > > > you don't end up with a soft deck like I have. Lots of people try > to > > > depend on the surface sealants between the plate and the deck, but > the > > work > > > that happens at the screw/plate/deck area will create an opening to > the > > > core where water can seep. By drilling out a hole twice as wide as > the > > > screws teeth, you gain a water proof buffer between the screws and > the > > > water absorbing core material. > > > > > > James Nichols > > > > > > -----Original Message----- > > > From: rhodes22-list-bounces at rhodes22.org [mailto: > > > rhodes22-list-bounces at rhodes22.org] On Behalf Of The Rhodes 22 Email > > List > > > Sent: Monday, May 4, 2015 9:12 AM > > > To: rhodes22-list at rhodes22.org > > > Subject: [Rhodes22-list] Cabin Roof Plate > > > > > > I managed to rip the cabin roof plate, used to connect the mast hoist > > > crane, off my boat yesterday, don't ask how, and I need to > reinstall. I > > > understand that this plate can be screwed to the cabin top or thru > > bolted. > > > I prefer to try and make the repair with the screws. I will use 3M > 5200 > > > Polyurethane Adhesive/Sealant from the plate to the cabin top. My > > question > > > is what I should fill the two screw holes with to re insert the > screws? > > I > > > assume this should be the West System #404 High Density Filler that > can > > be > > > injected into the striped screw holes and then re drill two 3/16" > pilot > > > holes once it has dried. Does this seem like to correct repair? > > > > > > > > > > > > ----- > > > Christopher P. Cowie > > > > > > 4400 MacArthur Blvd, NW > > > Suite 300 > > > Washington, DC 20007 > > > 202.342.2711 ex.204 ? 202.342.2691 fax ? 202.270.1470 mobile [ > > > ccowie at cowieassociates.com] > > > > > > > > > > > > -- > > > View this message in context: > > > http://rhodes-22.1065344.n5.nabble.com/Cabin-Roof-Plate-tp49793.html > > > Sent from the Rhodes 22 mailing list archive at Nabble.com. > > > > > > __________________________________________________ > > > To subscribe/unsubscribe go to > > > http://www.rhodes22.org/mailman/listinfo/rhodes22-list > > > > > > For the list Charter and help with using the mailing list and > archives > > go > > > to http://www.rhodes22.org/list > > > __________________________________________________ > > > > > > > > > __________________________________________________ > > > To subscribe/unsubscribe go to > > > http://www.rhodes22.org/mailman/listinfo/rhodes22-list > > > > > > For the list Charter and help with using the mailing list and > archives > > go > > > to http://www.rhodes22.org/list > > > __________________________________________________ > > > > > > __________________________________________________ > > > To subscribe/unsubscribe go to > > > http://www.rhodes22.org/mailman/listinfo/rhodes22-list > > > > > > For the list Charter and help with using the mailing list and > archives > > go > > > to http://www.rhodes22.org/list > > > __________________________________________________ > > > > > __________________________________________________ > > To subscribe/unsubscribe go to > > http://www.rhodes22.org/mailman/listinfo/rhodes22-list > > > > For the list Charter and help with using the mailing list and archives > go > > to http://www.rhodes22.org/list > > __________________________________________________ > > > > __________________________________________________ > > To subscribe/unsubscribe go to > > http://www.rhodes22.org/mailman/listinfo/rhodes22-list > > > > For the list Charter and help with using the mailing list and archives > go > > to http://www.rhodes22.org/list > > __________________________________________________ > > > __________________________________________________ > To subscribe/unsubscribe go to > http://www.rhodes22.org/mailman/listinfo/rhodes22-list > > For the list Charter and help with using the mailing list and archives go > to http://www.rhodes22.org/list > __________________________________________________ > > __________________________________________________ > To subscribe/unsubscribe go to > http://www.rhodes22.org/mailman/listinfo/rhodes22-list > > For the list Charter and help with using the mailing list and archives go > to http://www.rhodes22.org/list > __________________________________________________ >
To use your email application to send a messsage to the webmaster rather than this form, .
Your post is being sent... 