2015-05-22; 12:33:20 EDT
Member Since
2014-05-06
Posts: 3821
Hi Bob, Sounds like you had similar but different stuff. This comes as a sort of tape - about 1/2 inch wide and quite thin. It's rolled up with something like wax paper to keep it from sticking to itself - about 8" in diameter - enough for me forever - and I keep pulling off 6" or a foot to give to people. I've had it for 3 years and hasn't changed. Note again: He says it's definitely NOT for below waterline. You just pull off a small amount - it stretches till it breaks. Then roll it around in your hand and mash it around base of fitting or screw. It never "sets up" - always pliable and a little sticky. You'll invariably use too much and it will squeeze out. Can lightly score with a small, not too sharp knife blade and pull away. Clean up any residue with mineral spirits. He said he has a jib track installed for something like 30 years and 30,000 miles of ocean and never leaked. He's pulled things off after 10 years and it's still pliable and sticky. If you find that article, he explains so many things so well with lots of high quality close up pics. Two biggies: 1) make a little cone at top of your bolt hole so lots of butyl around top of bolt and 2) Have someone hold bolt so it can't turn and someone else tighten the nut. -- View this message in context: http://rhodes-22.1065344.n5.nabble.com/Screw-pulled-out-on-anchor-mount-tp49911p49940.html Sent from the Rhodes 22 mailing list archive at Nabble.com.See the original archive post