2015-05-25; 19:04:33 EDT
Member Since
2014-05-06
Posts: 3821
Curtis: I am planning to do as you suggest - apply smoked Plexiglas with special double-sided tape and glazers sealant. I have done the research and made the window pieces, figured out a clamping system and obtained the materials. I hope to be installing the windows in a few weeks once other repairs are finished - and I get up the nerve. The best set of instructions for this that I have found on line is here: http://www.thecoastalpassage.com/windows.html . Total material costs for Plexiglas, tape and sealant is about $300 Canadian which probably means about half that in the US. This is my second try. First time was about in about 1993 when I did everything wrong. Those were the pre-internet days for me. I used the wrong sealant (silicone), attached the glass snug with screws, and used Lexan rather than acrylic Plexiglas, to name only a few mistakes. Thermal expansion eventually resulted in the Lexan breaking at the screw holes and the silicone leaked. I also used clear Lexan that I painted black on the inside. The paint peeled. Even so, it lasted about 10 years without serious issues. I chose to make one window for each side rather than three. Three windows reduces the expansion factor and might make installation easier but I like the looks of the single piece. This time I will try it without using any hardware. The adhesive tape is supposed to be as strong as the hardware and allows for thermal expansion. The problem is that the sides of the cabin is a complex curve. While the tape is tenacious I want have a system to clamp the panels in place while the tape and sealant cure. I have experimented with clamping systems both complex and simple and settled on the simple one. It works in dry runs but whether it will work once the tape and sealant is applied is something to be learned from experience - and I hate learning from experience as it is almost always bad experience. I have attached some pictures of the clamping system I intend to use. If you want more information just ask. I also attached a picture of the boat with the previous Lexan windows just so you can get an idea of what it looks like. If you are wondering what the ring is that the clamp is attached to, that is the new chainplate I have installed to replace the old ones. I assume something similar could be rigged using the original chainplates. If you are interested, I will let you know what happens - when I get up the nerve. Graham Window clamps (2).jpg Window clamps (4).jpg Agile 4-01.jpgSee the original archive post