2015-06-01; 15:06:37 EDT
Member Since
2014-05-06
Posts: 3821
Bob, Knot knowing the age of the connections I would start with the battery terminals, remove and replace with soldered connections. Then move up the wire and replace all the existing connections with soldered connectors and wire brush the terminals they connect to and then coat each and every one with liquid plastic. This will give you an almost permanent solution to your problem.........hopefully. Rummy PS Also look for any section of wire that might have a bad crimp in it. (Broken) In a message dated 6/1/2015 1:08:33 P.M. Eastern Daylight Time, rhodes22-list at rhodes22.org writes: Really ned some help here. Got the boat rigged and was checking all the moving parts only to find the motor lift inoperative. Called Stan and he sent me a new switch, which turned out not to be the problem. Began by tracing the power. batteries both check ok, 13+ volts. Lazarette terminals check good power. when checking the switch wires from the lazarette to the up/down rocker switch at the switch end, got fluctuating voltage ( all over the place). lift motor works fine when hooked to separate battery. Stan is mulling it over, but we idon’thave an answer yet. Any Ideas? Feel free to call. Thanks Bob Allen Fairfax, VA 703 599-7818See the original archive post