The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Window replacement update

2015-06-03; 12:31:56 EDT

Member Since

2014-05-06

Posts: 3821

Mary Lou:

I will paint the inside of the acrylic panel everywhere except where the
openings will be. I intend to do this by removing the protective paper
everywhere except the port opening, then paint the panel and finally remove
the paper over the opening once the panel is installed. In the picture I
provided with the panels painted the paper covering is still over the port
area so it looks solid. You can't see the paper covering in the picture. I
could remove the paper before I install the panel but it seems sensible to
leave that area protected from scratches and any sealant that might get
smeared on it during installation.

I have attached a picture showing the plywood template, for the panel, the
Formica template (white) for the opening and the two acrylic panels with the
protective paper still on and the opening areas marked.

The acrylic panel is deep tinted so perhaps nothing will show through but
the tinting is not opaque and I suspect that in sunlight the grey tape and
white cabin will show. I don't have a spare piece of the tinted acrylic to
test this as I had the dealer cut the original panel for me using a plywood
template that I provided. I should have asked for some scrap piece. I did
have some clear acrylic that I used to test painting and the cutting and
removal of the paper. I have attached a picture of the clear acrylic,
partially painted and with the opening protective paper pealed back on both
sides. That might make what I am describing a litter easier to follow.

I have attached a picture of the boat with the lexan windows that I attached
back in 1995. The picture was taken 20 years later when the paint had pealed
and you can see the cabin and peeling paint under through the Lexan. Hence
my obsession with using the right paint. 

For more about my paint selection I have attached a picture of panels of
Lexan coated with various paints along with observational comments. I think
it demonstrates fairly well why the barbeque paint seemed superior for this
task.

I hope that helps.

Graham 



Windows with openings marked (2).jpg

Sailboat under cover Aug 08.jpg

Paint for windows comparison.jpg

Paint and peal test.jpg
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting