The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Window replacement update

2015-06-03; 16:42:40 EDT

Member Since

2014-05-06

Posts: 3821

Bob:

Thanks for the suggestion. Last time I did this I used screws and would like
to avoid using any hardware at all this time. The difference in expansion
between the lexan and the fibreglass resulted in the lexan breaking around
many of the screws - especially at the ends of the Lexan panel. The only way
to use hardware is to enlarge the holes. Make sue the screws are dead
centre, use screws with a washer of screws with a broad head and be very
particular about how tight the screws are. They need to be tight enough to
seal the joint, especially with neoprene gasket that must be compressed to
seal, but loose enough to allow for expansion. No one can tell me how to
determine what that torque should be. Screws look stronger but in practice
create as many problems as they solve.

Many boats are manufactured today using the materials and process I intend
to use and without the use of any hardware. So the method is not new and was
certainly not invented by me. There is quite a bit on the internet about it
and some of the info and videos for the tape by 3M are quite impressive. If
the tape will hold glass panels in tall buildings around the world or steel
panels on trailers I doubt that melting will be a problem. Besides, in
Ontario we celebrate when the ice melts. The silicone is not used primarily
as the adhesive, the tape does that, but it is used to seal the joint. It
remains soft and flexible whether hot or cold.

The special problems associated with using this hardware-free method for
attaching acrylic panels to the Rhodes are:
1)  that the cabin sides on the Rhodes are curved - particularly lengthwise
but also twist vertically. The spring-back of the panel wants to pull the
joint apart so the adhesive qualities of the tape have to be sufficient to
overcome this until the panel eventually sets in the shape of the cabin.
2) the panels are large and that means greater expansion differences between
the acrylic and the fibreglass - so the tape and sealant must be
sufficiently flexible to allow for that movement and,
3) the size of the panel and shape of the cabin make placing the panel in
the exactly correct position and with no opportunity to reposition it likely
to be difficult. At this point I am pretty confident about the ability of
the tape and sealant to handle the first two points but the third point is
another matter and is the part I worry about most. But who knows? 

If the panels pop off for any reason I will let everyone know what went
wrong.



Graham 



See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting