The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Window replacement update

2015-06-03; 18:48:19 EDT

Member Since

2014-05-06

Posts: 3821

Graham,

I have been following your endeavor with great interest.  You have attempted
to test and solve each material problem (or feature) BEFORE trying it on the
Rhodes! This level of DIY capability is truly rare.  You are to be commended
for your efforts.

Now, about the issues that you still face.

1)"Spring Back" - Have you thought about heating the material when held in
place prior to applying the adhesives?  It generally takes very little heat
(hair dryer or paint stripper) CAREFULLY applied to the surface to cause a
permanent curvature in the material.  You must take care not to overheat the
exterior surface (causes bubbles and other distortions) while applying
enough heat to the material.  Be especially aware that the surface in
contact with the interior, the fiberglass cabin top, may act as a heat sink,
removing large amounts of the energy that you apply.  Commercial entities
would probably heat the window using a low temperature oven or strip heater
before applying to the cabin to acquire the curvature.

2)"Different Coefficients of Expansion" - I think that you have addressed
this concern with the tape and seal system that you are using.  I am not
familiar with the exact materials you have chosen to work with but, as you
have noted, the tape is used to seal glass and metal in buildings.  It
should therefore work well in your instance.

3)Alignment of window - Rather than starting at one edge and working to the
opposite side, is it possible to accurately mark the center location so that
you can start in the middle and work to each edge?  This should result in a
smaller error since only half of the panel remains to be fitted.  You may
also be able to leave the carrier on the tape until the position is
verified, similar to the way an auto windshield is replaced in the field.
The technician pulls the protective carrier off the tape as the windshield
is pressed into place.

I'm not sure if any of this is useful but I thought that I would try to
help.

Mike
s/v Windlass ('91)
Nissequogue River, NY



See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting