Jefferson:
I just saw one on ebay. Its a 0 degree flush hatteras type base. $19
Mine are actually not a 0 degree but are about 15 degrees. It would be pretty easy to put a little bend in the tubing if needed.
These could be hard to find premade. A good fabricator could make some stainless ones cheaper than you can buy them from west marine and much less whining than from other sources.
I think we all need to locate a good local stainless welder/fabricator for the coming part drought.
> On Jun 9, 2015, at 1:09 PM, The Rhodes 22 Email List <rhodes22-list at rhodes22.org> wrote:
>>> Hello all,
>> I'm planning to make an opening in my stern pulpit to accommodate a swim
> ladder. In order to do so I need to find a flush-mounted stanchion base that
> screws into the outside of the stern my boat is a 76 and the existing two
> mounts on the stern pulpit are aluminum. I called the factory and actually
> spoke to Stan, who said it would be too much trouble to look through their
> parts and see if they had some of the original aluminum bases, and didn't
> seem to have the mounts used on newer boats, unless I misunderstood. I
> called West Marine after checking their catalogue and they had nothing for
> sale. All stern pulpit stanchions seem to mount on the inside or surface of
> the hull.
>> So has anyone replaced their stern flush mounts on an older boat, and if
> so where did they find them? What do newer Rhodeses have as a base? Are they
> mounted flush to the stern or on top?
>> Help and advice greatly appreciated!
>> Jefferson
> Patience ('76)
> Lake Memphremagog, Quebec
>>> __________________________________________________
> To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list>> For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list> __________________________________________________
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.