The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

The Rhodes 22 Email List



Replaced Windows/Companionway Door Panels

2015-06-09; 22:31:37 EDT

Member Since

2014-05-06

Posts: 3821

You didn't sign your message so I am not sure who I am responding to.

Your ports look like a great improvement to me and should give you ports
that should never leak and at the fraction of the cost of new ports. I am
planning to do as you did with the companionway door except that I will not
be using wood trim. Yours looks terrific and I am now keen to do it. The
only bright work on my boat will be the tiller. I will either use aluminium
or composite lumber for the trim - probably the latter.

I also toyed with the idea of shaping the acrylic using heat but I would
need to build an oven that would hold pieces over 5'long and I was worried
that I would just ruin the piece. In theory you can shape the acrylic with a
heat gun but from what I read it is very difficult to get an even bend on a
large piece. As it turned out the acrylic took the shape very well and the
tape held it firmly in place.

Graham 

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting